SHARE

In many cases, a sprinkler head does not work since the top of its real estate is broken. Gradually, the top of a sprinkler head– the part that is exposed to the sun and other aspects– dries out, making it more vulnerable to cracking. Even a brand-new sprinkler head can suffer damage if it takes a direct shot from the lawn mower or lies where it gets knocked around and stepped on.

Repaired spray sprinkler heads can suffer damage to their gaskets, preventing the “pop-up” part from appearing or withdrawing. The equipments that own a rotary sprinkler head can stop working. But whatever the issue, and regardless of whether you are handling a repaired spray or rotary sprinkler head, you can fix most damaged sprinkler heads by replacing the leading and the equipment within, but leaving the body in place in the ground.

Getting the Guts Out
Many sprinkler heads are configured more or less like a jar. At the bottom or on the side of the container is a hole where water is available in. In the center of the container’s top is an opening through which the spraying part of the sprinkler pops up and sprays when enough water pressure faces the sprinkler head. On the majority of types of sprinkler heads, the top of this jar– think about it as the crown– loosens.

After making certain that your watering system is switched off, loosen the crown of your damaged sprinkler head. Ensure it is the crown, and not the entire sprinkler, that you are loosening. You might have to dig along the sides and hold the sprinkler body still to do this. When the crown is off, get rid of the whole inner works from the sprinkler body. Next, block the sprinkler body opening to keep dirt out. A plastic water or soda bottle benefits this; simply turn it over and drop it in.

Take the Sprinkler Guts Shopping
If your watering system was expertly set up, you might have to go to a watering supply shop to find a coordinating replacement sprinkler head. The staff there needs to have the ability to find an appropriate match, and can even install a nozzle that matches the one from the broken sprinkler head. When you get back home, all you have to do is remove the top and take the guts from the brand-new sprinkler head, drop them into the body of the old one, and screw the brand-new top securely back into place.

One Last Pointer
If your sprinkler head broke because it is in a place where it frequently gets stepped on, you can protect it. When the ground is damp, put the PVC over the sprinkler head, then push it down till the rim of the PVC sits about half an inch above the top of the sprinkler.

NO COMMENTS

LEAVE A REPLY